TM 5-6675-326-14
6-9.4 Replace Paper Disk - Continued
b. Turn thumbscrew to move mounting assembly away from paper disk.
c.
Pry up old paper disks with knife and remove.
d. Remove any remaining glue with alcohol and a brush.
INSTALLATION:
a.
b.
c.
d.
Spread three or four drops of general purpose glue along edge of paper disk.
Reinstall new disk on planimeter surface. Press down firmly.
Trim excess paper from edges with knife. Remove any excess glue from edges
Slide encoder housing onto mounting bar. Tighten thumbscrew.
Section IV. ORGANIZATIONAL MAINTENANCE
6-10 There are no assigned organizational maintenance tasks for this equipment.
Section V. DIRECT/GENERAL SUPPORT
6-11 REPAIR PARTS; SPECIAL TOOLS; TEST, MEASUREMENT,
AND SUPPORT EQUIPMENT.
MAINTENANCE
AND DIAGNOSTIC EQUIPMENT (TMDE);
6-11.1 For authorized common tools and equipment, refer to the Modified Table of Organization and Equipment
(MTOE) applicable to your unit.
6-11.2 Special tools, TMDE, and support equipment are not required for this equipment.
6-11.3 Repair parts are listed and illustrated in the Repair Parts and Special Tools List (TM5-6675-326-24P) cov-
ering direct/general support maintenance for this equipment.
6-12 DIRECT/GENERAL SUPPORT PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS).
There are no PMCS at the direct/general support level for the QPS.
6-13 DIRECT/GENERAL SUPPORT TROUBLESHOOTING.
6-13.1 General.
6-13.1.1 Direct/general troubleshooting procedures cover the most common malfunctions that may be repaired
at the direct/general level. Repair or adjustment requiring specialized equipment is not authorized unless such equip-
ment is available. Troubleshooting procedures used at lower levels should be conducted in addition to the direct/gener-
al support troubleshooting procedures.
6-13.1.2 This manual cannot list all the possible malfunctions or every possible test/inspection and corrective ac-
tion. If a malfunction is not listed or corrected by a listed corrective action, notify your supervisor.
6-146
Change 1
