TM5-6675-326-14
6-14.2 Aline Planimeter Encoder - Continued
b .
With technical acetone, remove resin covering from adjustment
potentiometers, P1 and P2.
c .
Remove four screws and washers from top of auto-scaler.
L i f t
o f f t o p .
d.
Plug encoder into E1 encoder socket on back of auto - scaler.
e.
Set encoder switch to E1 .
CAUTION
f .
Plug
Plug transformer power cable into auto-scaler
b e f o r e c o n n e c t i n g i t t o w a l l o u t l e t.
F a i l u r e
to do so could result in damage to auto-scaler.
power transformer cable into POWER supply jack on back
panel of auto-scaler.
g .
Plug power transformer cable into wall outlet.
CAUTION
Make sure power is OFF before attaching
d i p - c l i p t o U 1 c h i p.
Failure to do so
could result in damage to auto-scaler.
h.
Attach dip-clip to U1 chip on main logic PC board.
6-150
