TM 5-6675-326-14
6-14.1 Replace Planimeter Encoder - Continued
INSTALLATION:
a.
b.
c.
d.
e.
f.
g.
Reinstall new encoder in housing.
Make sure the new encoder is parallel with the bottom of the housing and placed exactly between the
marks made on the housing.
Reinstall two hex head screws on side of encoder housing.
Insert cable in housing. Reinstall cable retaining screw.
Reinstall cable bracket. Secure with screw.
Slide encoder housing onto mounting bar of planimeter.
Tighten thumbscrew holding encoder housing on planimeter.
6-14.2 Aline Planimeter Encoder
PERSONNEL REQUIRED: 1 Special electronic devices repairer MOS 35E
TOOLS: 3/16-in. flat-tip screwdriver
1/8-in. flat-tip screwdriver
No. 2 cross-tip screwdriver
No. 2 jeweler’s screwdriver
5/64-in. socket-head screw key
Dip-clip (14 pin)
TEST EQUIPMENT: Multimeter
MATERIALS/PARTS: Acrylic orange resin
Technical acetone
a.
Remove planimeter encoder from housing (para 6-14.1).
Change 1
6-149
