TM 5-6675-326-14
1-6.2 Preparation for Movement - Continued
b.
c.
d.
e.
f.
g.
h.
i.
j.
k.
l.
Install tiedowns in tiedown sockets.
Secure straps and remove slack from straps.
WARNING
HIGH VOLTAGE
Turn power off before disconnecting power cable. Death or serious injury may
result.
Turn OFF equipment switches.
Set circuit breakers to OFF.
Turn OFF main circuit breaker.
Turn OFF safety switch.
Disconnect main power cable from power source. Disconnect power cable from power entry panel.
Disconnect telephone lines from telephone binding posts.
Remove ground cable from power entry panel.
Remove ground cable from ground rod by loosening wing nut on rod.
Remove ground rod from ground,
(1)
(2)
(3)
(4)
(5)
(6)
Remove slide hammer assembly from van body.
Screw slide hammer rod into coupling of ground rod. Put slide hammer on slide hammer rod and
slide collar onto slide hammer rod. Screw coupling nut onto top of slide hammer rod.
Pull ground rod out of ground by thrusting the slide hammer upward against the collar.
When first section is completely out of ground, unscrew slide hammer rod, and screw into next sec-
tion of ground rod.
Remove remaining two sections of ground rod following steps (1) thru (4).
Wipe dirt from ground rods. Reinstall ground rods and slide hammer assembly into van.
Change 1
1-25
