TM5-6675-326-14
2-14.5 Replace Split-Stage Light Table - Continued
c. Deflate air shocks to allow access to capscrew. Remove four
capscrews and washers from air shocks.
d .
Block table frame.
e .
Remove side braces.
(1) Remove 22 capscrews and washers from sides and base of
t a b l e .
(2) Remove shims.
(3) Slide braces out from underneath table.
f .
Remove two bolts securing rear legs of table.
g .
Remove two bolts securing front legs of table .
h .
Slide defective table to center aisle and remove from van.
INSTALLATION:
a .
Install new table, and secure front legs with two bolts.
b .
Secure rear legs of table with two bolts .
c. Reinstall shims and side braces, and secure with 22 capscrews
and washers.
d .
Reinstall four washers and capscrews in air shocks.
I n f l a t e
a i r s h o c k s.
e. Remove tape, and uncoil power cord.
f .
Plug in power cord, and turn power ON.
2-15 PREPARATION FOR STORAGE OR SHIPMENT.
In the event that the split-stage light table must be removed from
the section for repair or replacement, refer to TM 740-90-1 for storage
i n s t r u c t i o n s.
2-49
