TM5-6675-326-14
2-6.2 Operating Procedures - Continued
d .
Shut down light table.
( 1 ) R e w i n d f i l m o n r e e l .
(2) Remove film reels.
Hold film reel with one hand.
Use
other hand to pull grooved spindle-retracting knob from
locked position and move to retract position .
(3) Set ON/OFF switch to OFF.
(4) Set carriage clutch switch to OFF.
(5) Set main power switch to OFF.
(6) Cover view stages with masking assemblies.
( 7 ) U n p l u g p o w e r c o r d.
CAUTION
Do not touch optical surfaces
w i t h b a r e f i n g e r s.
F i n g e r p r i n ts
will hinder equipment performance .
( 8 ) M o v e o p t i c a l m o u n t t o f a r r i g h t r e a r p o s i t i o n.
( 9 ) S e c u r e o p t i c a l m o u n t w i t h s p r i n g c l i p s.
(10) Remove and store optics.
(11) Remove and store reel brackets.
(12) Remove and store clipboard.
( 1 3 ) L o w e r o p t i c a l m o u n t . I n s t a l l s h i p p i n g b r a c k e t.
( 1 4 ) C o v e r w i t h d u s t c o v e r.
2-6.3 Preparation for Movement
2-7
t h a t
2-32
a .
Perform all shut down light table (para 2-6.2d) steps except
covering with dust cover .
b .
R e i n s t a l l a l l m o u n t i n g b r a c k e t s , a n d t i g h t e n b o l t s.
c . C o v e r l i g h t t a b l e w i t h d u s t c o v e r.
OPERATION UNDER UNUSUAL CONDITIONS.
O p e r a t i o n o f t h e s p l i t - s t a g e l i g h t t a b l e i s l i m i t e d t o c o n d i t i o ns
will not damage aerial roll film or stereoscope.
