TM5-6675-326-14
2-6.1 Assembly and Preparation for Use - Continued
(3) Long loop take-up threading.
CAUTION
Do not close view stages when film is
threaded in long loop position.
Damage
t o f i l m m a y r e s u l t.
(a) Push stage separator knob down and to the left.
Make sure that view stages separate.
(b) Remove center accumulator roller by pinching
spring-loaded latches and lifting from between
view stages .
( c ) I n s e r t f i l m s u p p l y r e e l b e t w e e n f r o n t b r a c k e t a nd
c e n t e r i d l e r b r a c k e t . F r o n t b r a c k e t d r i v e s p i n d le
engages key slot on reel.
(d) Loosen black knurled locking knob on center idler
bracket. Move bracket toward film reel , and engage
bearing on bracket with center hole in reel .
A d j u s t p o s i t i o n s o t h a t f i l m r e e l i s s e c u r e l y h e ld
and has very slight end - play.
(e) Tighten black knurled locking knob on center idler
b r a c k e t.
( f ) I n s t a l l t a k e - u p r e e l a t o p p o s i t e e n d o f t a b l e u s i ng
same procedure.
2-27