TM 5-6675-325-14
CAUTION
Hold magnetic cards by edge. Be sure hands
other materials may damage magnetic cards.
are clean.
Grease, oil, or
(3) Load
(4) Tape
(5) When
preprogrammed card (paragraph 5-6.2h), Program I, into calculator.
drawing or map to be measured to table.
multiplying counts by one constant, key in constant press
(6) Press CLEAR button to clear auto-scaler.
(7) Using point counter pen, make point count.
(8) Press PRINT to obtain results of count.
(9) To make point count with two to four constants, follow steps (1) through
(4).
(10) When multiplying counts by two to four constants, key in each constant
(12) Press CLEAR
(13) Using point
(14) Press PRINT
button to clear auto-scaler.
counter pen, make point count.
to obtain results of
(15) Change X MEMORY switch to 2.
(16) Press CLEAR button to clear auto
(17) Using point counter pen, make poi
(18) Press PRINT to obtain results of
count.
scaler.
nt count.
count.
(19) Repeat steps (13) through (18) if there is another constant being used.
x.
Standard volume run using contour method.
(1) Assemble QPS with planimeter.
(2) Activate QPS.
(a) Plug foot switch into ACCU input jack on back panel of auto-scaler.
(b) plug linear measuring probe into E1 encoder socket on back panel of
auto-scaler.
5-70
