TM 5-6675-324-14
Measuring areas with planimeter.
o.
(1) Assemble QPS with planimeter.
(2) Activate QPS.
(a) Plug foot switch into PRINT input jack on back panel of auto-scaler.
(b) Plug remote tracer switch into ACCU input jack on back panel of
auto-scaler.
(c) Plug planimeter into E2 encoder socket on back panel of auto-scaler.
(d) Plug power transformer cable into power supply jack on back panel of
auto-scaler.
(e) Plug power transformer cable into wall outlet.
(f) Plug power cord into back of calculator.
(g) Plug power cord into wall outlet.
(h) Set encoder OFF/E2/E1 switch on back panel of auto-scaler to E2.
(i) Set AUDIO/OFF switch on back panel of auto-scaler to AUDIO.
(j) Set auto-scaler B/ACCU/A/OFF switch to A.
(k) Set auto-scaler MAN/AUTO switch to MAN. ,
(1) Set auto-scaler X MEMORY to 1.
(m) Set calculator OFF/ON to ON.
(n) Set calculator MAN/TRACE/NORM switch to NORM.
(o) Set PRGM/RUN switch to RUN.
(P) Press following keys:
CAUTION
Hold magnetic cards by edge. Be sure hands are clean. Grease, oil, or
other materials may damage magnetic cards.
(3) Load preprogrammned magnetic card (paragraph 5-6.2h), Program I, into
calculator.
(4) Tape map or drawing to be measured to table.
(5) Select correct tracer arm length.
5-55
