TM 5-6675-324-14
NOTE
Moving reed switch to right (as viewed from rear) increases leading edge
blank space and moving to left decreases it.
f. Adjust position of reed switch so that width of leading edge blank
space is 2 0.5 mm (0.08 0.02 in.) when copying test sheet, and
tighten screw.
NOTE
Leading edge blank space may vary slightly when rear panel is mounted
because of the magnetic field of the magnet that operates the reed switch.
Reinstall upper rear panel.
g.
Make 10 test copies and average measurements.
h.
i.
Turn power switch to O (OFF).
Remove upper rear panel, and locate J402 and J405.
j.
3-206