TM 5-6675-324-14
3-20.31
Adjust Leading Edge Blank Space and Paper Loop.
MOS: 35E, Special Electronic Devices Repairer
TOOLS: No. 2 Cross Tip Screwdriver
Machinist's Rule
SUPPLIES: NA Test Sheet
Rubber Hatting
Jumper Wire
WARNING
Electrical shock hazard. You must stand on rubber matting as a protective
measure before performing this procedure. Death or serious injury could
result.
Turn power switch to 0 (OFF).
a.
b. Remove upper rear panel of copier.
Loosen, but do not remove screw holding RS2 in place.
c.
d. Place NA test sheet on platen.
e. Turn power switch to 1 (ON).
3-205
