TM 5-6675-324-14
ALINE ALONG THIS LINE
w.
Remove screws and peel off defective seals. Clean off old adhesive.
x.
Install the new seals so that their inner edges are at the same
position as the edge of developer layer on the developing cylinder.
Reinstall screws but do not tighten.
Clean and install developing cylinder.
Press firmly against seal while tightening mounting screw.
Reinstall the bearings by lining up previous matchmarks.
aa.
ab.
Reinstall rear spacer roller and gear with grip ring.
ac.
Reinstall ratchet spring.
Reinstall front spacer roller and secure with grip ring.
ad.
3-203
