TM 5-6675-323-14
NOTE
Calculator will print the following information after the first measurement:
***Elevation
***Section of contour loop
Additional measurements will provide values for intermediate volume and
total volume.
0 . 0 0 Intermediate volume in cubic yards
0 . 0 0 Total volume in cubic yards
(20) Move to next contour loop.
(21) Release remote tracer switch.
(22) Repeat steps (18) and (19) until desired volume is determined.
( 2 3 ) To change contour interval when next loop to be measured is at a
different interval, key in new interval. Press
and a .
(24) If last elevation is not even contour interval, key in value for last
elevation.
Press
and c.
Repeat steps (18) through (23).
(25) To start a new
run,
press
or
and
b
to
initiate
memory.
Repeat
steps (12) through (18).
M e r g i n g volume runs.
y.
( 1 ) Assemble QPS with planimeter.
(2) Activate QPS.
P l u g foot switch into ACCU input jack on back panel of auto-scaler.
(a)
(b)
P l u g remote tracer switch into PRINT input jack on back panel of
auto-scaler.
(c)
P l u g p l a n i m e t e r i n t o E1 e n c o d e r s o c k e t o n b a c k p a n e l o f a u t o - s c a l e r .
(d)
P l u g p o w e r transformer cable into POWER supply jack on back panel of
auto-scaler.
( e ) P l u g transformer power cable into wall outlet.
P l u g power cord into back of calculator.
(f)
P l u g power cord into wall outlet.
(g)
( h ) S e t e n c o d e r 0 F F / E2 / E1 s w i t c h o n b a c k p a n e l o f a u t o - s c a l e r t o E1
(i) Set AUDIO/OFF switch on back panel of auto-scaler to AUDIO.
9-73