TM 5-6675-323-14
3 - 2 4 . ORGANIZATIONAL TROUBLESHOOTING. There are no organizational troubleshooting
procedures assigned for this equipment.
3 - 2 5 . MAINTENANCE PROCEDURES. There are no organizational maintenance procedures
assigned for this equipment,
3 - 2 6 . PREPARATION FOR STORAGE OR SHIPMENT. Contact your battalion for packing and
shipping instructions.
Section X DIRECT/GENERAL SUPPORT MAINTENANCE
3-27. REPAIR PARTS. SPECIAL TOOLS: TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT
(TMDE) ; AND SUPPORT- EQUIPMENT.
3-27.1
C o m m o n Tools and Equipment.
For authoriaed common tools and equipment
r e f e r to the Modified Table of Organization and Equipment (MTOE) applicable to your
unit.
3-27.2 Special Tools: Test. Measurement, and Diagnostic Equipment; and S u p p o r t
Equipment.
Special Tools, TMDE, and Support Equipment is listed in the applicable
repair parts and special tools list and in Appendix B of this manual.
Repair parts are listed and illustrated in the Repair Parts
3-27.3 Repair Parts.
and Special Tools List, TM 5-6675-323-24P covering direct/general support
maintenance for this equipment.
3-28. DIRECT/GENERAL SUPPORT TROUBLESHOOTING PROCEDURES.
a. Direct/general support troubleshooting procedures cover the most common
malfunctions that may be repaired at the direct/general support level. Repair or
adjustment requiring specialized equipment is not authorized unless such equipment
is available.
Troubleshooting procedures used by lower level maintenance should be
conducted in addition to the direct/general support troubleshooting procedures.
b.
If the graphics plotter does not power up when turned on, verify that 120 V
ac is present at the receptacle.
If voltage is not present, plug equipment into
receptacle with power available and proceed with equipment troubleshooting.
Perform
no-power procedures for dead receptacle (Table 1-4).
NOTE
Sufficient data is not available for you to test or troubleshoot printed
circuit boards. When associated wiring, ribbon cables, power cords and
other related electrical components have been eliminated as possible
faults, then the printed circuit boards must be substituted, one for one,
until the fault is isolated.
3-227
