TM 5-6675-323-14
PLOTTER OPERATION AND PROGRAM ERRORS - Cont
Table 3-21.
Error
Error No.
Displayed
Explanation
PLOTTER ROM ERRORS - Cont
P7
axe, ltr INSTRUCTIONS
EXECUTED
O c c u r s on axe and ltr instructions because ROM recognizes
these instructions but cannot execute them.
This error flags
a l l a x e a n d ltr i n s t r u c t i o n s f o r p u r p o s e o f c o n v e r t i n g 9 8 2 5
programs.
CALCULATOR STOP KEY CANCELLED OPERATION
P8
Occurs on any instruction when plotter fails to respond for
three seconds after STOP key has been pressed. This error is
most likely to occur when pen is traveling slowly.
TRANSMISSION ERROR
po
Computer has received an illegal ASCII input from plotter.
p1
INSTRUCTION NOT RECOGNIZED
Plotter has received illegal character sequence.
p2
WRONG NUMBER OF PARAMETERS
T o o many or too few parameters have been sent with instruc-
tion.
BAD PARAMETER
p3
Parameters sent to plotter with instruction are out of range
for that instruction.
ILLEGAL CHARACTER
p4
Character specified as parameter is not in allowable set for
that instruction.
3-212
