TM 5-6675-323-14
Table 3-20. PLOTTER PROGRAMMING LANGUAGE - Cont
S t a t e m e n t Identification and Use
Program
Statement
S t a t e m e n t , Syntax, Explanation, and Input Instructions
w r t 7 0 5 , "CS (-4)"
w r t - Cont
Character sets command designates one of five sets (-4) as
standard character set. This character set will be used for
a l l l a b e l i n g a n d l e t t e r i n g o p e r a t i o n s . C h a r a c t e r set is
automatically set whenever plotter is initialized.
NOTE
Plotter, when initialized, automatically speci-
fies ANSI-ASCII character set (set ) as both
" s t a n d a r d " a n d " a l t e r n a t e " s e t s . The p c l r
s t a t e m e n t , however, designates 9825 character
s e t (set 1) as standard set and set as alter-
nate set.
Following keys are used to switch from
standard character set to alternate set and back:
S e l e c t standard set = SHIFT F2
S e l e c t a l t e r n a t e s e t = S H I F T F3
Shown below are characters contained in set .
These characters correspond to those on computer
They are shown in order (from left to
right) of decimal-equivalent value of their ASCII
codes (32-126).
S h o w n next are symbols in various c h a r a c t e r s e t s
t h a t are changed from set . The p l o t t e r w i l l p e r f o r m
a n automatic backspace before drawing any of the
s h a d e d symbols.
3-207
