TM 5-6675-323-14
NOTE
Initial values of P1 and P2 in plotter units are:
P1 = 5 2 0 , 380 (X, Y)
P2 = 1 5 7 2 0 , 10380 (X, Y)
The following procedure is used to relocate either or both of these points in order
to expand or narrow field of plot:
P r e s s LINE power switch on, then press ENTER and
(1) Initialize
plotter:
CHART HOLD buttons.
(2) Using pen controls on front panel, move pen to desired location for P1
or P2.
( 3 ) When pen reaches location, set point by pressing ENTER followed by
pressing either P1 or P2, depending on which point is to be located.
NOTE
P1 and P2 do not have to be set so that they are still in initial
As shown in illustration, they can also be set in lower
relationship.
right/upper left relationship.
3-175
