TM 5-6675-323-14
(12) Enter sample print program in computer.
( a ) Press ERASE A.
( b ) Press lbl "I AM A 9872 PLOTTER".
( c ) Press STORE, LIST, and EXECUTE. Check printout of program.
(d) Press RUN.
( e ) Check to see plotter draws "I AM A 9872 PLOTTER."
d. HP-IB Operational Test.
WARNING
Death or serious injury may occur from electrical shock. Plotter is equipped
with a three-conductor power cable which grounds plotter. Do not operate
plotter from an ac outlet that does not have connected ground pin.
CAUTION
B e sure power is off before plugging ROM's or H P - I B I n t e r f a c e c a b l e i n t o
e q u i p m e n t . D a m a g e to equipment will result.
(1) Check that computer power is off.
Plug HP-IB cable into I/O slot in
back of computer.
(2) Plug ROM into slot in front of computer.
(3) Turn on computer.
V e r i f y lazy "T" (
) is on computer.
NOTE
If lazy "T" does not appear, remove HP-IB Interface and press RESET. If it
still does not appear, refer to direct/general support maintenance.
E n t e r program line shown below.
(4)
P r e s s EXECUTE and verify that display shown above appears.
(5)
3-167
