TM 5-6675-323-14
d. HP-IB operational test.
WARNING
Death or serious injury may occur from electrical shock. Plotter is
equipped with three-conductor power cable which grounds plotter. Do not
operate plotter from AC outlet that does not have connected ground pin.
CAUTION
B e sure power is off before plugging HP-IB ROMs or HP-IB Interface cable
i n t o equipment or damage to equipment will result.
(1) Turn off computer power.
Plug HP-IB card into I/O slot in back of
computer.
S lot
in front of
(2) Plug plotter extended and general I/O ROM into
computer.
(3) Turn on computer. Verify lazy tee "
"
display
is
on
computer.
NOTE
If lazy tee does not appear, remove HP-IB Interface and press RESET. If
it still does not appear, troubleshoot computer.
(4) Enter program line shown below.
PROGRAM LINE:
rds (7,A,B,C)
D; dst A,B,C,D
DISPLAY
0.00
64.00
213.00
76.00
(5) Press EXECUTE and verify that display shown above appears.
(6) If display does not return after line is executed, press RESET and
rotate HP-IB Interface select code switch to 0, then back to 7, carefully with a
screwdriver.
(7) Repeat step (4).
(8) If display does not return or display is incorrect, card is defective.
3-65
