TM 5-6675-323-14
(c) Position paper squarely against ridge at bottom of pIaten and
against paper stop on left side. Smooth paper with back of hand.
( d ) Press CHART HOLD switch. (CHART LOAD should go off).
(10) Load pens.
WARNING
To avoid possible injury to fingers, always turn plotter off when directly
storing pens.
(a) Turn off (0) LINE power switch.
(b) Remove cap from first pen.
(c)
Place
tip
of
pen
in
boot
at
base
of
stable.
(d) Gently press pen down and in until it snaps in place.
(e) Repeat for all four pens.
(11) Perform four-color dynamic test.
(a) Insert 9800 series test cartridge into computer.
( b ) Load test cartridge by pressing STOP, ERASE, A, EXECUTE, RESET,
lbd3, and EXECUTE.
(c) When computer displays ENTER MODEL # TO BE TESTED, press 9872,
SHIFT, A, and CONTINUE.
(d) When computer displays ENTER SELECT CODE . . . . . . press 705 and
CONTINUE.
(e) When computer displays ENTER # OF TIMES TO RUN TEST . . . , press 1
and CONTINUE.
(f) When computer displays LOAD PAPER & THEN PRESS CONTINUE, check that
paper is loaded and press CONTINUE.
( 9 ) Printer should print 9872B PLOT COMPLETE in approximately 6
minutes.
C o m p a r e plot produced.
3-63
