TM 5-6675-323-14
Press LINE power switch on front base of plotter. Plotter should respond as
follows:
(1) Pen raises.
(2) Pen moves to lower right corner of platen.
3-6.2 Initial Adjustments, Daily Checks, and Self-Test.
a.
Perform the operation confidence test as follows:
(1) Turn LINE power switch to off (0).
(2) Check that power cables are connected and voltage switches are set
for 120 V ac operation,
Check that HP-IB Interface is not connected.
(3)
(4)
Turn LISTEN ONLY switch to 0.
Turn CONFIDENCE TEST switch to 0.
(5)
C h e c k that logic ADDRESS switches are set to 11.
(6)
(7)
Initialize
plotter:
(a) Press LINE power switch.
( b ) Press ENTER key.
( c ) Press CHART HOLD switch.
(8)
M o u n t paper.
(9)
Install pen in pen arm.
(10)
Turn CONFIDENCE TEST switch to I.
After completion of plot, pen
should stop in lower left corner of platen, and all lamps on front
panel should be turned on.
3-58
