TM 5-6675-323-14
3-6.
OPERATION UNDER USUAL CONDITIONS .
NOTE
In general, independent operation of
the plotter is confined to
self-testing and editing charts. All
other operating procedures use a
computer to control the operation of
the plotter, using programs written
by the operator, and inputted through
the computer.
3-6.1 Assembly and Preparation for Use.
VOLTAGE SELECTOR
a.
Check that selector switches on rear panel are set at 120 V.
b.
Plug female end of power cord into jack on rear panel of plotter.
WARNING
Death or serious injury may result from electrical shock. Plotter is
equipped with three-conductor power cable which grounds plotter.
Do not
operate plotter from ac outlet that does not have connected ground pin.
CAUTION
B e sure power is off before plugging ROM's or HP-IB Interface cable into
e q u i p m e n t , or damage to equipment will result.
Plug male end of power cord into grounded ac outlet.
c.
d.
P l u g one end of HP-IB Interface in rear of computer. Connect other end of
HP-IB Interface into jack on rear panel of plotter. Turn holding screws to fasten
connection.
3-57
