TM 5-6675-323-14
1-15. ORGANIZATIONAL TROUBLESHOOTING PROCEDURES.
a. Organizational troubleshooting procedures cover the most common malfunctions
Repair or adjustment requiring
that may be repaired at the organizational level.
specialized equipment is not authorized unless such equipment is available.
Troubleshooting procedures used by the operator should be conducted in addition
to the organizational troubleshooting procedures.
b. This manual cannot list all the possible malfunctions or every possible test/
If a malfunction is not listed or is not
inspection and corrective action.
corrected by a listed corrective action, notify your supervisor.
c. For unidentified malfunctions, use the facing schematic or the foldout
located at the end of this manual for further fault analysis.
d.
I f any component of the Analysis Section does not power up when turned on,
If voltage is not present, plug
verify that 120 V ac is present at the receptacle.
e q u i p m e n t into receptacle with power available and proceed with equipment trouble-
Perform no-power troubleshooting procedures for dead receptacle (Table
shooting.
1-4).
T a b l e 1-4. ORGANIZATIONAL TROUBLESHOOTING
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
WARNING
Be sure power is off when checking continuity at
Electrical shock hazard.
troubleshooting points. Death or serious injury could result from failure
to do so.
1.
FLUORESCENT CEILING LAMP IS INOPERATIVE.
S t e p 1.
Check for continuity of fluorescent lamp switch
(a) If continuity exists, proceed to step 2.
( b ) If continuity does not exist, replace switch (paragraph 1-
1-57
