TM 5-6675-323-14
Section IV ORGANIZATIONAL MAINTENANCE
1-11.
L U B R I C A T I O N I N S T R U C T I O N S . This equipment does not require lubrication at
this level of maintenance.
1 - 1 2 . REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT
(TMDE); AND SUPPORT EQUIPMENT.
1-12.1 Common Tools and Equipment.
F o r authorized common tools and equipment,
r e f e r to the Modified Table of Organization and Equipment (MTOE) applicable to your
unit.
1 - 1 2 . 2 Special Tools; Test, Measurement, and Diagnostic Equipment; and Support
Equipment.
S p e c i a l Tools, TMDE, and Support Equipment is listed in the applicable
repair parts and special tools list and in Appendix B of this manual.
1-12.3 Repair Parts.
Repair parts for this equipment are listed in the Repair
P a r t s and Special Tools List, TM 5-6675-323-24P covering organizational maintenance
for this equipment.
1-13.
SERVICE UPON RECEIPT.
NOTE
T h e section may be received mounted on a chassis, or as a van body for
mounting on an available transporter, or on site.
Inspection of the
chassis is covered in TM 5-2330-305-14.
Inspection of the air
conditioner/heater is covered in TM 5-4120-367-14.
1 - 1 3 . 1 Checking Unpacked Equipment.
a. Inspect the equipment for damage incurred during shipment. If the equipment
has been damaged, report the damage on DD Form 6, P a c k i n g Improvement Report.
(1) Visually inspect the section exterior starting at the rear to cover rear,
curbside, roadside, front, top, and bottom.
I n s p e c t for damage, tears, breaks or
corrosion.
(2) Enter section and inspect for broken equipment, tool boxes, chairs, or
e q u i p m e n t loose and not secured,
(3) Close doors and vents to determine if light leaks exist.
(4) Inspect doors for damage, torn or rotted seals, and tightness of closure.
(5) Inspect interior for evidence of water damage, fungi, mildew or
corrosion.
( 6 ) Report damage or discrepancies in accordance with AR 735-11 and AR 735-
11-2.
1-52
