TM 5-6675-321-14
e.
Plan how puncture is to be covered with tape before applying any tape.
Length and width of tape,
number of tape strips, overlapping, and how
t a p e i s a p p l i e d w i l l a f f e c t s e a l i n g c a p a b i l i t y o f r e p a i r . E a c h p i e ce
of tape should extend about 1-1/2 in. (3.81 cm) beyond sealant it will
c o v e r.
If this will require more than one strip of tape, tape should
overlap about 1/2 in. (12.7 mm).
If three or more strips of tape are
r e q u i r e d , c e n t e r s t r i p s h o u l d b e a p p l i e d f i r s t.
Holding it taut, apply tape perpendicular to panel skin. Do not apply
w i t h r o l l i n g m o t i o n e i t h e r e n d - t o - e n d o r c e n t e r - t o - e n d s .
Do not rub
e a c h s t r i p i n p l a c e i n d i v i d u a l l y.
A p p l y a l l s t r i p s l i g h t l y w i t h p r o p e r
overlap and rub into place.
g .
If necessary, damaged tape can be replaced; however, it should be
removed with careful peeling motion to avoid damage to sealant. If
sealant also peels back, new sealant should be applied. Complete
removal of old sealant is not necessary.
Permanent repair by direct
support, or higher category of maintenance, should be made as soon as
p o s s i b l e.
1-16.14 Replace Tiedown Socket.
MOS: 83FJ6, Reproduction Equipment Repairer
TOOLS :
Cross Tip Screwdriver
Flat Tip Screwdriver
SUPPLIES: Tiedown Socket
a.
Remove screws from tiedown socket.
Pry defective socket from floor.
c .
Install new tiedown socket.
Rotate new tiedown socket enough to avoid
installing screws in old screw holes.
d.
Reinstall screws.
1-77
f .
b .
