TM 5-6675-319-14
d .
e.
f .
g .
h.
i .
j .
k.
Lift control panel clear of frame, being careful not to break any wires .
Remove nuts with plastic washers and carefully lift EDC1 card from
c o n s o l e.
Tag and desolder wires from card.
Replace defective card.
Solder wiring to new card and install into console.
Reinstall control panel to frame.
Turn on circuit breaker.
Turn on MASTER POWER switch.
9-20.13 Replace Raster Edge Control Potentiometer.
MOS: 35E, Special Electronic Devices Repairer
TOOLS:
Flat Tip Screwdriver
Solder/Desolder Set
1/16 in. Hex Head Key Wrench
1/2 in. Combination Wrench
SUPPLIES: Modified Potentiometer
Solder (Item 30, Appendix E)
WARNING
Death or serious injury may occur from electrical shock unless power is
t u r n e d o f f b e f o r e s e r v i c i n g.
9-154
