TM 5-6675-319-14
c .
Remove
d. Remove
e .
Remove
f. Remove
f l o o r .
g.
Remove
wall mounting bolts and washers from wall.
floor mounting bolts and washers from floor.
film/paper processor (paragraph 2-16.24).
bolts securing replenisher tank and sump tank assemblies to
Place assemblies to side out of way.
sink from van through cargo door.
h.
Install new sink to floor with mounting bolts. Connect drains to tee.
i .
Secure sink to wall with mounting bolts and washers.
j .
Plug in sink power cord.
k . T e s t o p e r a t i o n o f r e f r i g e r a t i o n u n i t.
l .
Test drain system for leaks.
m.
Reinstall replenisher tank and sump tank assemblies.
n.
Reinstall film/paper processor (paragraph 2-16.24).
3-17. PREPARATION FOR STORAGE OR SHIPMENT. Contact your battalion for packing and
shipping instructions.
Section V DIRECT/GENERAL SUPPORT MAINTENANCE
3-18. REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT
(TMDE); AND SUPPORT EQUIPMENT.
3-18.1 Common Tools and Equipment. For authorized common tools and equipment,
refer to the Modified Table of Organization and Equipment (MTOE) applicable to your
u n i t .
3-18.2 Special Tools; Test, Measurement,and Diagonstic Equipment; and Support
E q u i p m e n t . Special Tools, TMDE, and Support Equipment is listed in the applicable
repair parts and special tools list and in Appendix B of this manual.
3 - 1 8 . 3 R e p a i r P a r t s . R e p a i r p a r t s a r e l i s t e d a n d i l l u s t r a t e d i n t h e R e p a ir
Parts and Special Tools List, TM 5-6675-319-24P covering direct/general support
maintenance for this equipment.
3-43
