TM 5-6675-319-14
NOTE
The following procedure is a disassembly/assembly sequence. Only dis-
assemble the developer rack as far as necessary to perform the repair.
a.
Turn off all processor switches.
b.
Remove top cover, tank covers, and crossovers.
c .
Slowly remove rack assembly by lifting upward. Allow time for excess
fluid to drip back into tank and place rack on table.
d. Rinse rack assembly with water. Wipe with damp sponge.
NOTE
The developer rack assembly is identical to the fixer rack/turnaround
assembly with the following exceptions:
The other
i d l e s i de PLATE.
exception is the manner in which the rollers are attached to the
e.
Remove screws and tie rod handle.
f. Remove screw and spacer from drive roller shaft on idle side plate.
2-151
This assembly contains a developer spray system which consists of
perforated tubing and supply tube.
