TM 5-6675-319-14
l .
Remove processor from frame and remove from the section through rear
d o o r s.
m.
Install new processor on mounting frame and secure with bolts,
n.
Connect external tubing .
o .
Reinstall heater exhaust hose.
p.
P o s i t i o n p r o c e s s o r o v e r a i r s h o c k s,
r a i s e c a s t e r s , a n d i n s t a l l f o ur
bolts and washers.
q.
Connect power cable terminals and reinstall processor power access
c o v e r.
2-17.
PREPARATION FOR STORAGE OR SHIPMENT.
Contact your battalion for packing and
s h i p p i n g i n s t r u c t i o n s.
Section V
DIRECT/GENERAL SUPPORT MAINTENANCE
2-18.
REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT
(TMDE) ; AND SUPPORT EQUIPMENT.
2-18.1 Common Tools and Equipment.
For authorized common tools and equipment,
refer to the Modified Table of Organization and Equipment (MTOE) applicable to your
u n i t .
2-18.2 Special Tools; Test, Measurement. and Diagnostic Equipment; and Support
Equipment.
Special Tools, TMDE, and Support Equipment is listed in the applicable
repair parts and special tools list and in Appendix B of this manual.
2 - 1 8 . 3 R e p a i r P a r t s .
Repair parts are listed and illustrated in the Repair Parts
and Special Tools List, TM 5-6675-319-24P covering direct/general support mainte-
nance for this equipment .
2-19.
DIRECT/GENERAL SUPPORT TROUBLESHOOTING PROCEDURES.
a.
Direct/general support troubleshooting procedures cover the most common
malfunctions that may be repaired at the direct/general support level. Repair or
adjustment requiring specialized equipment is not authorized unless such equipment
i s a v a i l a b l e.
Troubleshooting procedures used by lower level maintenance should be
conducted in addition to the direct/general support troubleshooting procedures.
b. This manual cannot list all the possible malfunctions or every possible
t e s t / i n s p e c t i o n a n d c o r r e c t i v e a c t i o n.
I f a m a l f u n c t i o n i s n o t l i s t e d o r c o r r e c t ed
b y a l i s t e d c o r r e c t i v e a c t i o n , n o t i f y y o u r s u p e r v i s o r.
c. For unidentified malfunctions use the following schematics or the foldout
located at the end of this manual for further fault analysis.
2-128
