TM 5-6675-319-14
2-16.24 Replace Paper Processor.
MOS: 83FJ6, Reproduction Equipment Repairer
PERSONNEL: Two persons are required to perform this procedure.
TOOLS: Hose Clamp Pliers
12 in. Adjustable Wrench
9/16 in. Combination Wrench
3/4 in. Combination Wrench
5/16 in. Combination Wrench
Flat Tip Screwdriver
SUPPLIES: Pail
Hose Clamps
Rags (Item 25, Appendix E)
WARNING
Death or serious injury may occur from electrical shock unless power is
t u r n e d o f f b e f o r e s e r v i c i n g.
a.
T u r n o f f c i r c u i t b r e a k e r .
b. Remove processor power access cover.
Tag and disconnect electrical
connections to processor .
c .
Loosen conduit retaining nut and slide away from connection.
WARNING
Injury from chemical burns or blindness may occur if photographic chemicals
splash in eyes or on sensitive skin areas. Wear eye protection and be
sure eyewash and running water is available before working on processor.
d. Drain chemical solutions from processor (paragraphs 2-6.2 and 2-6.3).
NOTE
Last of chemical solutions will have to be drained into plastic pail or
drip pan as lowest points will not normally flow into drains .
2-126
