TM 5-6675-319-14
2-16.3 Adjust Transport Speed.
MOS:
83FJ6, Reproduction Equipment Repairer
TOOLS:
Flat Tip Screwdriver
Stop Watch
Ruler
SUPPLIES:
Photographic Paper
a.
Zero SPEED indicator by adjusting the screw directly below the indicator
f a c e.
b. Mark a test piece of processing paper at 12 in. intervals.
c .
Switch on the processor and set SPEED control knob for 24 in./minute
speed (approximately mid-scale).
d.
Put paper in feed tray, and note time required for the measured portion
of paper to pass the feed tray edge.
e.
From the following elapsed time chart, obtain actual processor speed.
2-94
