TM 5-6675-319-14
2 - 7.
OPERATION UNDER UNUSUAL CONDITIONS. This equipment is designed for operation
only in a controlled environment.
Section III OPERATOR MAINTENANCE
2 - 8.
LUBRICATION INSTRUCTIONS.
WARNING
S e r i o u s i n j u r y m a y o c c u r i f f i n g e r s , c l o t h i n g o r o t h e r m a t e r i a l s a r e
caught in moving parts.
CAUTION
Do not get oil or grease on the racks or crossovers, or in the solution
tanks. Damage to equipment may occur.
NOTE
These lubrication instructions are mandatory.
2 - 8 . 1.
Main Drive Chain. Apply a small amount of ball and roller bearing grease
(Item 5, Appendix E) to chain surface once a month.
2-8.2 Worm Drive Gears. Semiannually, apply a small amount of ball and roller
bearing grease (Item 5, Appendix E) to surface of gear teeth .
2-8.3 Main Drive Motor. Semiannually, apply four to five drops of light oil
(nondetergent) (Item 21, Appendix E) into oil cups on top of bearing housings.
2-8.4 Microswitch Plunger and Roller. Semiannually, apply a small amount of light
oil (nondetergent) (Item 21, Appendix E) to plunger and roller. Wipe off excessive
oil.
2-8.5 Wash Squeegee Driver Gears. Semiannually, apply a small amount of ball and
roller bearing grease (Item 5, Appendix E) to surface of gear teeth .
2 - 9.
TROUBLESHOOTING PROCEDURES.
a .
The table lists the common malfunctions which you may find during operations
or maintenance of the film/paper processor system. You should perform the test/
i n s p e c t i o n s a n d c o r r e c t i v e a c t i o n s i n t h e o r d e r l i s t e d .
b . T h i s m a n u a l c a n n o t l i s t a l l t h e p o s s i b l e m a l f u n c t i o n s o r e v e r y p o s s i b l e t e s t/
i n s p e c t i o n a n d c o r r e c t i v e a c t i o n . I f a m a l f u n c t i o n i s n o t l i s t e d o r i s n ot
c o r r e c t e d b y a l i s t e d c o r r e c t i v e a c t i o n , n o t i f y y o u r s u p e r v i s o r .
2-50
