TM 5-6675-318-14
(2) Turn on the modem on the remote receiver/processor by entering code 230.
( 3 ) E n t e r c o d e 5 9 o n t h e r e m o t e r e c e i v e r / p r o c e s s o r t o c h e c k t h e m o d e m
s t a t u s.
Display should show MODM only; if a code is displayed, refer to table 4-7
and take appropriate action before continuing.
Table 4-7. CODE 59 DISPLAYS FOR MODEM STATUS
NOTE
This code applies only to Version 110 and above units.
Enter code 59 to display the status of the communications
symbols may be displayed:
OFF
- Modem not being used.
E
- Error detected in modem.
S
-
Modem
currently
running
self-test.
T
- Modem currently transmitting message.
- Modem receiver currently locked onto incoming
R
- Modem received incoming message.
modem.
The following
s i g n a l .
C
- Incoming message changed instead of repeating.
e . D a t a c o l l e c t i o n .
Press the clear (C) key to start data collection. Record
the number of passes necessary to obtain the required accuracy (Table 4-4).
f . D i s p l a y a n d r e c o r d c o n t r o l s i t e d a t a.
(1) Press clear (C) key and key in Code 53.
NOTE
The following data is in terms of satellite datum. If datum conversion
i s r e q u i r e d , r e f e r t o p a r a g r a p h 4 - 6 . 3 . 4.
( 2 ) P r e s s t h e e n t e r ( E ) k e y t o r e a d t h e i n i t i a l d i s p l a y , t h e n p r e s s t he
enter (E) key to erase and view each succeeding display in turn.
I n t e r p r e t t he
displayed data in accordance with Table 4-5, page 4-62.
(3) Press the enter (E) key to read the initial 3D display, then press the
enter (E) key to erase and view each succeeding diisplay in turn.
I n t e r p r e t t he
displayed data in accordance with Table 4-6, Code 63 and record on DA Form 1959.
4-72
Change 3
L
