TM 5-6675-318-14
Table 4-21. CODE DESCRIPTIONS - Cont
While the unit is processing data from a particular pass, it displays that pass
number.
Code 46, Control Translocate From Tape - Cont
Processing Pass 17
When it finishes processing all pass data, it displays CODE, SITE if a new site
record is encountered, END if the end of data on tape is encountered, or DONE if all
corresponding data in memory from the other site has been used.
Done Processing
Code 47, Control 3D Position From Tape
This code is operative only in the off-line mode. Enter code 47 to compute a 3D
position fix from the raw satellite data on tape. The tape will stop after reading a
site record. Code 47 must be re-entered to continue .
When code 47 is entered, the unit asks the user how many satellite passes to
process.
I n i t i a l D i s p l ay
Enter either no number, one number, or two numbers. Entering no number causes all
passes in the site to be processed. Entering one number indicates the number of
passes to process in the 3D position computation.
Process 5 Passes
4-132
