TM 5-6675-318-14
(12) Enter sample print program in computer.
( a ) Press ERASE A.
( b ) Press lbl "I AM A9872 PLOTTER".
( c ) Press STORE, LIST, and EXECUTE. Check printout of program.
(d) Press RUN.
( e ) Check to see plotter draws "I AM A 9872 PLOTTER."
d.
HP-IB
operational
test.
WARNING
Death or serious injury may occur from electrical shock. Plotter is equipped
with a three-conductor power cable which grounds plotter. Do not operate
plotter from an ac outlet that does not have connected ground pin.
CAUTION
B e sure power is off before plugging ROM's or HP-IB Interface cable into
equipment.
D a m a g e to equipment will result.
Plug HP-IB cable into 1/0 slot in
(1) Check that computer power is off.
b a c k of computer.
(2) Plug ROM into slot in front of computer.
(3) Turn on computer.
Verify lazy "T"
is on computer.
NOTE
If lazy "T" does not appear, remove HP-IB Interface and press RESET. If it
still does not appear, refer to direct/general support maintenance.
(4) Enter program line shown below.
rds (7, A, B, C)
D; dsp A, B, c, D
PROGRAM LINE:
76.00
64.00
0.00
213.00
DISPLAY:
(5) Press EXECUTE and verify that display shown above appears.
3-167
