TM 5-6675-318-14
In general, independent operation of the
plotter is confined to self testing and editing charts. All other operating proce-
dures use a computer to control the operation of the plotter, using programs written
by the operator and inputted through the computer.
A s s e m b l v and Prep a r a t i o n f o r U s e .
a.
Plug female end of power cord into jack on rear panel of plotter.
WARNING
Death or serious injury may occur from electrical shock. Plotter is
equipped with three-conductor power cable which grounds plotter. Do
n o t operate plotter from ac outlet that does not have connected ground
pin.
CAUTION
B e sure power is off before plugging ROM's or interface cable into
e q u i p m e n t , or damage to equipment will result.
b. Plug male end of power cord into grounded ac outlet.
c . Plug one end of interface ROM in rear of computer. Connect other end of
interface into jack on rear panel of plotter. Tighten knurled screws to fasten
connection.
3-157
