TM 5-6675-316-14
(13) Lower teletype carriage hood.
(14) Type several lines to see if they are printed on paper straight and
paper does not bind at edges. If paper is not straight, repeat steps (6) through
(10) until it is straight.
h. Installing paper tape in teletype.
(1) Turn teletype power swi
(2) Remove and discard old
paper tape in tape punch is out.
(3) Insert paper tape roll
teletype cabinet. Insert roll so
tch to local position.
paper tape roll.
Press HERE IS key until all old
Turn off power.
into well by sliding hub of roll down slot in
that tape unrolls from top.
(4) Open tape punch cover and feed paper tape through slot in rear of punch.
Push tape in as far as it will go.
(5) Close tape punch cover.
(6) Turn power switch to LOCAL. Press ON.
(7) Press HERE IS key until paper tape comes out front of tape punch.
(8) If paper tape will not go through, pull tape out of tape punch, cut
several inches from end, and repeat steps (2) through (7).
i.
Using automatic tools.
All automatic drafting/scribing tools are mounted
used with pen lifting device.
For procedures concerning use of this device and
other drafting tools, including mounting attachments, and adjustments, refer to
applicable tool and procedure in Table 3-5.
and
3-80
