TM 5-6675-316-14
Table 3-5. USING AUTOMATIC DRAFTING TOOLS - Cont
Tool
Operating Procedure
2. Tangentially Controlled
MOUNTING
Device - Cont
e.
Push in mounting latch and push device down
again as far as it will go.
f. Release mounting latch.
NOTE
If mounting latch does not spring all the way back in place, gently lift
or push tangentially controlled device slightly until it does.
Latch
should fit into groove in shaft of device.
g.
Plug ribbon cable into device and connector on
X-carriage.
3-84
