TM 5-6675-316-14
(13) Remove scribing device from universal tool holder and with small screwdriver, pry scribing point out of
device. (Use tool for nylon screw found in accessory case.)
(14) Clean and store scribing device and point.
e. Manual tracing/drafting. Basic procedure involves drawing lines on drafting medium using lead holder
tool or ball point pen tool. Drawing points are moved over medium by moving X-and/or Y-carriages by hand.
(1)
(2)
(3)
(4)
NOTE
It is not possible to manually trace circles or curves without additional
equipment.
Set machine for manual operation (paragraph 3-6.3a).
Set XY display for operation (paragraph 3-6.3 b).
Select lead holder tool or ball point pen tool.
NOTE
Ball point pen tool will produce ink line of constant width. Lead holder tool will
produce graphite line of width which will only remain constant if point is kept
sharpened.
Mount correct tool and adjust height of point for operation (table 3-4, item 3 or 4).
3-74
Change 1