TM 5-6675-315-14
i.
Lift support bar up out of holding bracket. Pull conveyor belt assembly out front of machine.
j.
Remove conveyor belt from assembly and install new belt.
k.
Reinstall conveyor belt assembly.
l.
Reinstall drive shaft.
NOTE
Be sure that drive key at end of shaft engages cutter gears and shaft is seated.
m.
Reinstall locking nut, perform drive adjustment procedure (paragraph 2-35.2), and tighten lockscrew.
n.
Reinstall feed table.
o.
Reinstall cutter mechanism side panels.
p.
'Turn on circuit breaker.
q.
Turn on main power switch.
2-139
