TM 5-6675-315-14
Table 2-5. ORGANIZATIONAL TROUBLESHOOTING - Cont
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
5.
CUTTER RUNS FORWARD MOMENTARILY AND THEN SHUTS DOWN - Cont
Step 7. Check cutter reverse relay SR for continuity.
If not present, replace relay SR (paragraph 2-16.10).
6.
CUTTER BLADES MOVE SLOWLY, SLUGGISHLY, OR INTERMITTENTLY.
Step 1. Check for jammed material in cutter blades.
(a)
If blades are clear, proceed to step 2.
(b)
Remove jammed material.
Step 2. Inspect cutter drive V-belts.
(a)
Adjust loose belts as necessary (paragraph 2-16.1).
(b)
Replace any worn or broken belts (paragraph 2-16.8).
2-68
