TM 5-6675-315-14
Table 2-5. ORGANIZATIONAL TROUBLESHOOTING - Cont
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
2.
CUTTER MECHANISM WILL RUN IN REVERSE BUT NOT FORWARD - Cont
Step 1. Check safety switch swing plate for free movement.
(a)
If swing plate moves freely, proceed to step 2.
(b)
Remove cutter mechanism rear cover. Be sure that safety switch swing plate moves freely and is
not being held closed by material from cutting blade.
(c)
Remove any material jammed between swing plate and blades.
(d)
If swing plate does not move freely, loosen hex bolt one-half turn.
Step 2. Check rear safety switch SSS for continuity.
(a)
If continuity is present, proceed to step 3.
(b)
Replace rear safety switch (paragraph 2-16.16).
2-55