TM 5-6675-314-14
c. Turn clips 90° to left or right.
2-20
CAUTION
Glass surface must be handled with care to avoid chipping or breaking.
d.
Remove glass surface and set aside.
e.
Remove screws and front cover panel.
f. Remove bezel nut, label, and nut from power switch.
NOTE
Ground wire is not connected to switch.
Mark position for reinstallation.
g.
h.
i.
j.
k.
l.
m.
n.
o.
To remove defective power switch, pull to inside of board. Tag and
disconnect wires.
Remove defective switch.
Connect wiring to new power switch and remove tags.
Reinstall nut, label, and bezel nut.
Adjust for proper positioning of
power switch.
Reinstall front cover panel and secure with screws.
Reinstall glass surface.
Turn clips 90° to secure glass surface.
Reinstall screws on clips. Tighten all screws.
Plug in power cord and turn power switch ON.
