TM 5-6675-314-14
2-13. SERVICE UPON RECEIPT.
2-13.1 Checking Unpacked Equipment.
a.
Inspect the equipment for damage incurred during shipment. If equipment has
been damaged, report the damage on DD Form 6, Packing Improvement Report.
b.
Check the equipment against the packing list to see if the shipment is
complete.
Report all discrepancies in accordance with the instructions of DA Pam
738-750.
c.
Check to see whether the equipment has been modified.
2-14. ORGANIZATIONAL PREVENTIVE MAINTENANCE CHECKS AND SERVICES. There are
no organizational PMCS procedures assigned for this equipment.
2-15. ORGANIZATIONAL TROUBLESHOOTING PROCEDURES. There are no organizational
troubleshooting procedures assigned for this equipment.
2-16. ORGANIZATIONAL MAINTENANCE PROCEDURES.
a.
This section contains instructions covering organizational maintenance func-
tions for the portable tracing/scribing board.
Personnel required are listed only
if the task requires more than one.
b.
After completing each maintenance procedure, perform operational check to be
sure that equipment is properly functioning.
NOTE
The maintenance procedures for the portable tracing/scribing board
consist of replacing three different electrical components. A
multimeter is needed to determine which component is defective and
needs replacement.
INDEX
PROCEDURE
Replace Power Switch. . . . . . . . . . . . . . . . . . . . . . . .
Replace Power Cord. . . . . . . . . . . . . . . . . . . . . . . . .
Replace Ballast Transformer . . . . . . . . . . . . . . . . . . .
Remove/Install Mounting Bracket . . . . . . . . . . . . . . . . . .
2-18
PARAGRAPH
2-16.1
2-16.2
2-16.3
2-16.4
