TM 5-6675-302-14&P
CHAPTER 4
ORGANIZATIONAL MAINTENANCE INSTRUCTIONS
Section I. SERVICE UPON RECEIPT OF MATERIAL
Refer to paragraph 2-1 for inspecting and servicing
the equipment,
Refer to paragraph
Section II. MOVEMENT TO A NEW WORKSITE
2-5 for moving the equipment
to a new worksite and refer to paragraph 2-6 for
reinstallation after movement.
Section III. REPAIR PARTS, TOOLS AND EQUIPMENT
4-1. Special Tools and Equipment. Special tools
required for organizational maintenance on the
target set are listed in table 4-1 and appendix E.
4-2. Special Tools.
Table 4-1 Special Tools
Item
NSN
Fig. No.
Use
Screwdriver, flat tip
5120-00-446-2860
2-3
Circular level adjustment.
Pin, adjusting
6675-00-353-4103
2-3
Adjust tribrach and theodolite adjusting
screws.
Wrench, tripod (Model 242406)
5120-00-378-9520
2-3
Tripod
leg
adjustment,
removal
and
installation.
Key, socket head screw (Model
512041-011-8393
2-4
Tripod leg adjustment, removal and
USATS-79
installation.
4-3. Repair Parts. Organizational maintenance
repair parts are listed and illustrated in appendix
E.
Section IV. LUBRICATION INSTRUCTIONS
Refer to paragraph 3-3 for lubrication instructions
for the target set.
Section V. PREVENTIVE MAINTENANCE CHECKS AND SERVICES
4-4. General. To insure that the target set is ready
serious damage or failure. Defects discovered dur-
for operation at all times, it must be inspected
ing operation of the unit shall be noted for future
systematically so that the defects may be
corrections, to be made as soon as an operation has
discovered and corrected before they result in
ceased. Stop operation which would damage the
4-1
![](//www.tpub.com/assessment.jpg)