TM 5-3610-287-24
2-58.
REPAIR EXAUST FAN ASSEMBLY (CONT)
Tag and remove wires (10) on terminals of switch (9).
6.
7.
Remove wire nut (11) from wires (10).
8.
Untie knot in cable (12) and remove from receptacle box by gently
pulling through grommet (13).
9.
Open exhaust fan door.
Remove foam filter (14).
Remove screws (15), flatwashers, lockwashers, hex nuts (16), and
10.
fan (17).
Install new fan (17) with screws (15), flatwashers, lockwashers, and
11.
hex nuts (16).
Install fan guard (3) with screws (1), flatwashers, lockwashers, and
12.
hex nuts (2).
13.
Install two cable clamps (5) with screws (4).
14.
Thread cable (12) through grommet (13) on receptacle box. Tie knot in
cable to prevent cable from being pulled through grommet (13).
15.
Connect wire (10) with wire nut (11). Secure wires (10) to
switch (9).
16.
Install switch (9) with screws (8).
17.
Install switch cover (7) with screws (6).
18.
Install foam filter (14), open exterior door, and close exhaust fan
door.
19.
Plug power cord into wall outlet.
20.
To test operate, set exhaust fan switch to ON.
2-59. REPLACE WALL HEATER
This task covers: a.
Removal b. Installation
INITIAL SETUP
Tools
Light machine repair tool kit (appendix B, section III, item 11)
Cross-tip screwdriver
Pliers
Crimping tool (appendix B, section III, item 14)
2-180
