TM 5-3610-287-24
2-57.
REPLACE EXHAUST FAN ASSEMBLY (CONT)
5.
Remove screws (7) and clamps (8).
6.
Open assembly door, remove foam filter (9), and check external exhaust
fan door latch (10) to ensure that latch is not hooked.
7.
Remove screws (11) and exhaust fan assembly (12).
INSTALLATION
1.
Position external exhaust fan door latch (10) through slot in new
exhaust fan assembly (12). Install assembly (12) with screws (11).
2.
Install foam filter (9) in exhaust fan assembly door and secure door.
3.
Install clamps (8) with screws (7).
4.
Thread wires (5) through grommet (6) and tie knot in wires.
Connect black wire (5) to switch (4).
Connect white wire (5) and
5.
secure with wire nut (13).
Install switch (4) with screws (3).
6.
7.
Install plate cover (2) with screws (1).
Plug power cord into wall outlet.
8.
9.
To test operate, open exterior exhaust fan door and set exhaust fan
switch to ON.
REPAIR EXHAUST FAN ASSEMBLY
Exhaust fan assembly is repaired by replacing:
Fan
FAN
INITIAL SETUP
Tools
Light machine repair tool kit (appendix B, section III, item 11)
Cross-tip screwdriver
Flat-tip screwdriver
Combination wrench set
Materials/Parts
Fan, 13222E4374
Masking tape (appendix C, item 29)
Lead pencil (appendix C, item 13)
2-178
