TM 5-3610-287-24
2-59.
REPLACE WALL HEATER (CONT)
WARNING
q ELECTRICAL
HAZARD. There are two heater circuit
breakers. Set specific circuit breaker for wall heater
being replaced to off. Failure to observe this warning
may result in death or serious injury.
q Do
not operate wall heater with grill removed or with
wall heater removed from enclosure. Serious personal
injury may result.
1.
Set specific HEATER circuit breaker to OFF.
2.
Remove control knob (1) by pulling gently.
WARNING
Grill may fall when last screw is removed. Failure to hold
grill with free hand may result in personal injury.
3.
Remove screws (2) and grill (3).
4.
Remove screw (4), cupped washer, and wire (5).
5.
Tag wires (6) and cut below connections (7).
6.
Remove conduit locknut (8) and washer.
7.
Remove screws (9) and wall heater (10) from Section wall, pulling wires
(5) and (6) through housing.
INSTALLATION
1.
Insert wires (5) and (6) through new wall heater housing and install
wall heater (10) on Section wall with screws (9).
2.
Install washer and conduit locknut (8).
3.
Connect wires (6) and secure with new wire nuts (11).
4.
Install wide (5) with cupped washer and screw (4).
Install grill (3) with screws (2).
5.
6.
Install control knob (1).
2-182
