TM 5-3610-287-24
2-44.
REPAIR WATER TANK ASSEMBLY (CONT)
5.
Remove pipe coupling with copper fitting (6).
Loosen union (7) and clamp (8), then remove gate valve assembly (9).
6.
7.
Loosen clamp (10) and remove hose (11).
Remove nylon adapter (12).
8.
Remove T-assembly (13).
9.
10.
Push elbows (14) under water tank (15).
11.
Remove rubber molding (16).
12.
Remove lag bolts (17), lockwashers, and flatwashers.
Remove screws (18).
13.
Remove screws (19), lockwashers, flatwashers, and feeder board locking
14.
bracket (20).
Pull top of water tank (15) toward jogging table and into feeder board
15.
storage rack. Pull water tank (15) out enough to clear sink assembly
and remove.
16.
Remove elbows (14) from water tank (15).
NOTE
To prevent leakage, apply PTFE tape to all threaded pipe
connections in the following steps.
17.
Install elbows (14) on new water tank (15).
Position water tank (15) in feeder board storage rack and slide toward
18.
sink. Lift into position.
19.
Install screws (18).
20.
Install lag bolts (17), lockwashers, and flatwashers.
21.
Install feeder board locking bracket (20) with screws (19),
lockwashers, and flatwashers.
2-123
