TM 5-3610-287-24
2-41. REPLACE SINK CABINET (CONT)
5. Remove plastic covers (9) from floor of sink cabinet(4).
Remove lag bolts (10), lockwashers, and flatwashers.
6.
7.
Remove sink cabinet (4).
INSTALLATION
Position new sink cabinet (4).
1.
2.
Install lag bolts (10), lockwashers, and flatwashers.
Install plastic covers (9) in floor of sink cabinet (4).
3.
4.
Install screws (3) in back of sink cabinet (4).
Install pump mounting brackets (8) with hex bolts (7), lockwashers, and
5.
flatwashers.
Install auxiliary pump (6) and secure with screw (5).
6.
7.
Install angle bracket (2) with screws (l).
8.
Install sink top (para 2-40).
REPAIR WATER PIPING
Pressure switch b. Angle
Water piping is repaired by replacing: a.
valve c. Gate valve
PRESSURE SWITCH
INITIAL SETUP
Tools
Shop equipment common no. 1 tool kit (appendix B, section III, item 12)
Pipe wrench
Flat-tip screwdriver
Cross-tip screwdriver
Extension light
Materials/Parts
Pressure switch, 13226E4449
Close nipple, MS51846-20
Wire nut, 2978
PTFE tape (appendix C, item 30)
Masking tape (appendix C, item 29)
Lead pencil (appendix C, item 13)
2-106
